Phileg a écrit :Normalement sur les NC le fait d'avoir l'ABS non fonctionnel passe le moteur en mode dégradé, donc rouler comme cela alors que ce n'est pas prévu pourrait avoir des conséquences...
![Shocked :shock:](./images/smilies/icon_eek.gif)
Ben alors j'ai un modèle spécial, car la bete fonctionne à merveille
Je vais regarder ton lien guil22 ..... Merci
J'en reviens
![Laughing :lol:](./images/smilies/icon_lol.gif)
je pense qu'elle va rester comme çà. Car moi et le British + vu tous les cas de pannes et solution.. j'y arriverais jamais. Je vais au moins controler la propreté du capteur, si je le trouve
• The ABS indicator might blink while riding under the following conditions. This is temporary failure. Be sure to erase the problem
code (page 20-9).
Then, test ride the motorcycle above 10 km/h (6 mph) and check the problem code by retrieving the self-diagnosis system (page
20-8). Ask the rider for the riding conditions in detail when the motorcycle is brought in for inspection.
– The motorcycle has continuously run bumpy roads.
– The front wheel leaves the ground for a long time when riding (wheelie).
– Only either the front or rear wheel rotates.
– The ABS operates continuously.
– The ABS control unit has been disrupted by an extremely powerful radio wave (electromagnetic interference).
Problem
Code Function failure Detection Symptom/Fail-safe function Refer
A B to
–
• ABS modulator voltage input line
• Indicator related wires
• Speedometer
• ABS modulator
• ABS fuse 7.5 A (ABS MAIN)
• ABS indicator never come
ON at all 20-12
• ABS indicator stays ON at all
20-13
11 Front wheel speed sensor circuit malfunction
• Wheel speed sensor or related wires O O • Stops ABS operation 20-15
13 Rear wheel speed sensor malfunction
• Wheel speed sensor or related wires O O 20-17
12
Front wheel speed sensor circuit malfunction
• Wheel speed sensor or related wires
• Electromagnetic interference
O
• Stops ABS operation
20-15
14
Rear wheel speed sensor malfunction
• Wheel speed sensor, pulser ring or related
wires
• Electromagnetic interference
O 20-17
21 Front pulser ring
• Pulser ring or related wires O • Stops ABS operation 20-15
23 Rear pulser ring
• Pulser ring or related wires O 20-17
31 Solenoid valve malfunction (ABS modulator)
O O
• Stops ABS operation
20-19
32
33
34
37
38
41 Front wheel lock
• Riding condition O • Stops ABS operation
20-15
42 Front wheel lock (Wheelie)
• Riding condition O
43 Rear wheel lock
• Riding condition O 20-17
51
Motor lock
• Pump motor (ABS modulator) or related
wires
• ABS fuse 30 A (ABS M.)
O O
• Stops ABS operation
52 20-20
Motor stuck off
• Pump motor (ABS modulator) or related
wires
• ABS fuse 30 A (ABS M.)
O O
53
Motor stuck on
• Pump motor (ABS modulator) or related
wires
• ABS fuse 30 A (ABS M.)
O O
54
Fail-safe relay malfunction
• Fail-safe relay (ABS modulator) or related
wires
• ABS fuse 30 A (ABS SOL.)
O O
• Stops ABS operation
20-21